04-08-2021, 05:21 AM
Good afternoon,
I am developing a part using SLA 3D printing and obtaining some fairly decent results but because my part is very small I am getting an issue with resolution. I have read that DLP or similarly LCD 3D printing work in a slightly different way. I have also read that with an anti-aliasing tool, people have had a lot of success using DLP printers. Hence I am reaching out to see if anyone would be willing to test a print for me? I have contacted Elegoo directly, as they state very good specifications of their printers but they couldn't help and suggested I use this forum.
Would anyone be willing to help me and test a print? I am based in Bath, U.k.
My part consists of 121 cone shaped structures of height 0.6 mm and width 0.3 mm sat on a coin of 10 mm and thickness 2 mm. I print my parts supported and not directly onto the build plate and normally uses less than 1 ml of resin and 0.025 layer thickness. I have attached an .STL file and haven't added any supports/anti-aliasing features as I am not sure how to the stl, except through ChiTuBox/PreForm when setting up the print.
Any help will be greatly appreciated.
Thank you,
Joe
I am developing a part using SLA 3D printing and obtaining some fairly decent results but because my part is very small I am getting an issue with resolution. I have read that DLP or similarly LCD 3D printing work in a slightly different way. I have also read that with an anti-aliasing tool, people have had a lot of success using DLP printers. Hence I am reaching out to see if anyone would be willing to test a print for me? I have contacted Elegoo directly, as they state very good specifications of their printers but they couldn't help and suggested I use this forum.
Would anyone be willing to help me and test a print? I am based in Bath, U.k.
My part consists of 121 cone shaped structures of height 0.6 mm and width 0.3 mm sat on a coin of 10 mm and thickness 2 mm. I print my parts supported and not directly onto the build plate and normally uses less than 1 ml of resin and 0.025 layer thickness. I have attached an .STL file and haven't added any supports/anti-aliasing features as I am not sure how to the stl, except through ChiTuBox/PreForm when setting up the print.
Any help will be greatly appreciated.
Thank you,
Joe