02-04-2022, 11:38 AM
For sale is an upgraded Elegoo Mars 3D printer. It is in top operating and physical condition, with significant upgrades.
Elegoo's specs are:
This printer also has a Jackson (https://jacksonproducts.net/) dual rail Z-axis column, low backlash half-nut, and low height clamp knob (see photo, a $115 upgrade), and has been upgraded to the latest Mars Pro firmware. Also included is an 8 GB USB drive, a second build platform (both have drain brackets), five replacement FEP sheets, spare screws,, scrapers, etc.
The Jackson mast makes it a VERY stable and accurate machine. The LCD shutter has fewer than 20 hours on it.
A BIG bonus is an infrared curing oven (see photos) of my design. built upon a microwave oven chassis (retaining the timer and turntable) using a 30 Watt 405 nm infrared LED for fast post print curing.
I also have a kilogram of gray resin, alcohol and print cleaning supplies.
The latest Chitubox free slicing software (https://www.chitubox.com v1.9.1) is their best ever, very stable and quite capable.
Poor health forces sale of this and other electronic equipment (oscilloscopes, signal generators, etc.)--asking $250.00 plus actual shipping cost or reasonable offer for the printer--ask about other stuff.
platen #1 and Jackson dual mast:
Mars Pro firmware
platen #2 and Jackson dual mast:
Jackson dual mast:
Jackson upgraded half-nut:
Curing chamber lamp:
Curing chamber ON:
ditto;
Elegoo's specs are:
- System: ChiTu L5.5 Series
- Operation: 3.5 Inch Touch Screen
- Slicer Software: ChiTu DLP Slicer
- Connectivity: USB
- Printing Technology: LED Display Photocuring
- Light Source: UV Integrated Light(wavelength 405nm)
- XY Resolution: 0.047mm(2560*1440)
- Z Axis Accuracy: 0.00125mm
- Layer Thickness: 0.01-0.2mm
- Printing Speed: 22.5mm/h
- Power Requirements: 110-220V, 12V5A 60W
- Build Volume: 4.72 * 2.68 * 6.1 inches
This printer also has a Jackson (https://jacksonproducts.net/) dual rail Z-axis column, low backlash half-nut, and low height clamp knob (see photo, a $115 upgrade), and has been upgraded to the latest Mars Pro firmware. Also included is an 8 GB USB drive, a second build platform (both have drain brackets), five replacement FEP sheets, spare screws,, scrapers, etc.
The Jackson mast makes it a VERY stable and accurate machine. The LCD shutter has fewer than 20 hours on it.
A BIG bonus is an infrared curing oven (see photos) of my design. built upon a microwave oven chassis (retaining the timer and turntable) using a 30 Watt 405 nm infrared LED for fast post print curing.
I also have a kilogram of gray resin, alcohol and print cleaning supplies.
The latest Chitubox free slicing software (https://www.chitubox.com v1.9.1) is their best ever, very stable and quite capable.
Poor health forces sale of this and other electronic equipment (oscilloscopes, signal generators, etc.)--asking $250.00 plus actual shipping cost or reasonable offer for the printer--ask about other stuff.
platen #1 and Jackson dual mast:
Mars Pro firmware
platen #2 and Jackson dual mast:
Jackson dual mast:
Jackson upgraded half-nut:
Curing chamber lamp:
Curing chamber ON:
ditto;