11-01-2020, 04:31 PM
(This post was last modified: 11-01-2020, 04:31 PM by plate-of-shrimp.)
Hi,
After a failed print with the right side of the failure badly drooping, I ran Tools -> Exposure from the touchscreen. A photo of the result:
https://drive.google.com/file/d/1NaYnqtr...sp=sharing
This does not look too good to me.
Has anyone encountered something that looks like this?
-r
After a failed print with the right side of the failure badly drooping, I ran Tools -> Exposure from the touchscreen. A photo of the result:
https://drive.google.com/file/d/1NaYnqtr...sp=sharing
This does not look too good to me.
Has anyone encountered something that looks like this?
-r
ELEGOO Mars 2 Pro
ELEGOO Standard Resin (Gray)
ELEGOO Standard Resin (Gray)