Elegoo mars pro 2 and ECO Anycubic Resin

[Inmel]

Hello

Does anyone have an elegoo mars pro 2 and use Anycubic Eco resin?

If so, what exposure settings do you use?

I am having problems with this resin when it comes to printing all my pieces correctly with the elegoo mars PRO 2 standard configuration, I currently use 2.5s per layer and 6 lower layers of 80.

Someone uses this combination of resin and printer (Elegoo MARS 2 PROS and ECO ANYCUBIC RESIN / green Trans) and can help me by sharing their configuration? , even if it is not exactly the translucent green resin and if it is of another color it would be very helpful since it does not I am able to find any table with references for this printer on the internet or any forum.

Thank you very much and sorry for my bad English.

[cliffyk]

What problems if any are you experiencing?

[Inmel]

Some small pieces do not stick to the base and in others the finest supports are not created with the next failure of certain parts of the miniature.

[cliffyk]

What lift speeds are set in the Chitubox printer settings?



I have found the defaults for the MARS and MARS Pro to be too high, at 100 and 80 mm/minute. The settings for best results on my MARS are as shown above...